12.5K INJECTOR HEAD

An Injector head is the primary component of a capillary/coil injection system. During installation, the operator routes capillary/coil tubing from the spooler to the top of the injector and passes it through the tubing gooseneck. A series of grooved wheels on the gooseneck aid alignment and pre-straighten the tubing prior to entering the gripper blocks which are assembled into the drive chains. The drive chain configuration utilizes two opposing chains with replaceable gripper blocks to push (inject) or pull tubing utilizing a hydraulic cylinder dual-traction system.


 Data Sheet 12.5K IH


Performance Features

Pull Capacity

12,500 lb [5670 kg]1

Snub Capacity

2,500 lb [1134 kg]1

Tubing Range

Ø5/8”- Ø1” [18.9-25.4mm]

Velocity

Variable speed from 3 ft/min to 150 ft/min1

Gooseneck Radius

Typical R=37” [940 mm]

1 Max speeds and pull are based on 100% efficiency and may diminish slightly due to wear of components

Physical Characteristics

Tar Weight

3,500 lb [1588 kg]

Payload

3,000 lb [1361 kg]

MGW

6,500 lb [2948 kg]

Length

45” [1143 mm]

Width

42 ½” [1080 mm]

Height

53” [1347 mm]

Height w/gooseneck

91” [2312 mm]

HYDR Power Requirements

Max Pressure

3,000 psi [207 bar]

Min Flow

≥ 15 GPM [57 LPM]

Max Flow

≤ 35 GPM [133 LPM]

Standard Options

Lift Frame w/cert

Pull Tested (2.5 times rated load)

Sling Set  w/cert

WLL = 10,000 lb (tested at WLL X 2)

Stripper Bolt Plate Interface

8X ¾-10UNC on a Ø9.25” B.C.

Heat Treated Gripper Blocks

For increased run life and reliability

Available Certifcations3

DNV

2.7-3  

 

MACHINERY, ATEX

3Not standard, must be requested.