35K INJECTOR HEAD

An Injector head is the primary component of a capillary/coil injection system. During installation, the operator routes capillary/coil tubing from the spooler to the top of the injector and passes it through the tubing gooseneck. A series of grooved wheels on the gooseneck aid alignment and pre-straighten the tubing prior to entering the gripper blocks which are assembled into the drive chains. The drive chain configuration utilizes two opposing chains with replaceable gripper blocks to push (inject) or pull tubing utilizing a hydraulic cylinder triple-traction system.


 Data Sheet 35K IH


Performance Features

Pull Capacity

35,000 lb [15876 kg]1

Snub Capacity

10,000 lb [4536 kg]1

Tubing Range

Ø3/4”- Ø1 1/2” [19.1-38.1mm]

Velocity

Variable speed from 3 ft/min to 150 ft/min1

Gooseneck Radius

Typical R=48 [1219 mm]

1 Max speeds and pull are based on 100% efficiency and may diminish slightly due to wear of components

Physical Characteristics

Tare Weight

4,800 lb [2177 kg]

Payload

3,200 lb [1452 kg]

MGW

8,000 lb [3629 mm]

Length

55” [1397 mm]

Width

46” [1168 mm]

Height

77" [1956 mm]

Height w/gooseneck

145” [3683 mm]

HYDR Power Requirements

Max Pressure

4,500 psi [310 bar]

Min Flow

≥ 15 GPM [57 LPM]

Max Flow

≤ 35 GPM [133 LPM]

Standard Options

Lift Frame w/cert

Pull Tested (2.5 times rated load)

Sling Set w/cert

Pull Tested (2 X WLL)

Stripper Bolt Plate Interface

8X ¾-10UNC on a Ø9.25” B.C.

Heat Treated Gripper Blocks

For increased run life and reliability

Available Certifcations3

DNV

2.7-3  

 

MACHINERY, ATEX

3Not standard, must be requested.